Partes

No se requieren partes.

Go ahead and remove the dust bin. Then flip the roomba over and remove the battery.
  • Go ahead and remove the dust bin.

  • Then flip the roomba over and remove the battery.

Agregar Comentario

The upper housing is held in place by eight phillips #2 screws on the underside of the machine.  Removing the four screws around the battery compartment is the most difficult step in servicing the robot. The recess holes around the battery compartment, are 5.85 mm in diameter.  The thinest old school #2 phillips I could find, has a shank diameter of 5.90 mm.  Humm, did they do this on purpose to make working on these difficult? Well, the easiest way I found to overcome this problem was to ream out the holes to 1/4 inch.  I used the wrench from a tap and die set, an ordinary drill, and a drill collar; to carefully ream out the holes by hand.
  • The upper housing is held in place by eight phillips #2 screws on the underside of the machine. Removing the four screws around the battery compartment is the most difficult step in servicing the robot.

  • The recess holes around the battery compartment, are 5.85 mm in diameter. The thinest old school #2 phillips I could find, has a shank diameter of 5.90 mm. Humm, did they do this on purpose to make working on these difficult?

  • Well, the easiest way I found to overcome this problem was to ream out the holes to 1/4 inch. I used the wrench from a tap and die set, an ordinary drill, and a drill collar; to carefully ream out the holes by hand.

  • If you don't have all that, you can use a regular drill. Be careful though not to hit the screw as the drill bit with strip it and make it very hard to remove. The factory sets these screws very tight and they are difficult to take out if they have not been removed before.

Agregar Comentario

Now go ahead and remove all eight screws.  (please excuse the battery in the picture, you should have removed it back in step 1.)
  • Now go ahead and remove all eight screws. (please excuse the battery in the picture, you should have removed it back in step 1.)

Agregar Comentario

If you made it this far, the worst is past.  Carefully maneuver the top housing until it comes free.
  • If you made it this far, the worst is past. Carefully maneuver the top housing until it comes free.

  • The control panel in the top is connected by a ribbon cable, detach it at the circuit board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

SamGeorge

Miembro Desde 11/01/13

152 Reputación

1 Guía escrita

Thank you! You speed up my repair time to half

Michael Fiala - Contestar

Great!

Now where can I aquire a new belt?

That is my biggest problem

Jef Hern - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 10

Todo El Tiempo: 1,160