Introducción

In order to perform any sort of repair on the throttle body unit, it must first be removed from the engine by following these step by step instructions

Partes

No se requieren partes.

Firstly Disconnect  battery Always take the negative terminal off first.
  • Firstly Disconnect battery

    • Always take the negative terminal off first.

    • '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job

Agregar Comentario

Locate throttle body on right side of engine, it is between the intake tube and intake manifold.
  • Locate throttle body on right side of engine, it is between the intake tube and intake manifold.

Agregar Comentario

Locate throttle linkage cable assembly.
  • Locate throttle linkage cable assembly.

Agregar Comentario

Twist the assembly clockwise. Twist the assembly clockwise.
  • Twist the assembly clockwise.

Agregar Comentario

Slide both slackened cables off assembly’s guides.
  • Slide both slackened cables off assembly’s guides.

Agregar Comentario

Locate the two hoses on the top of the throttle body. Gently lift the hoses off.
  • Locate the two hoses on the top of the throttle body.

  • Gently lift the hoses off.

Agregar Comentario

Use a flat head screwdriver to loosen the hose clamp attaching the intake tube to the throttle body.
  • Use a flat head screwdriver to loosen the hose clamp attaching the intake tube to the throttle body.

Agregar Comentario

Remove the intake tube from the throttle body.
  • Remove the intake tube from the throttle body.

Agregar Comentario

Locate wiring clip on the underside of the throttle body.
  • Locate wiring clip on the underside of the throttle body.

Agregar Comentario

Press down on the locking mechanism before gently removing the wiring clip. Press down on the locking mechanism before gently removing the wiring clip.
  • Press down on the locking mechanism before gently removing the wiring clip.

Agregar Comentario

Locate throttle linkage arm. Open the locking clip with a flat head screwdriver. Pry off the linkage arm with a flat head screwdriver.
  • Locate throttle linkage arm.

  • Open the locking clip with a flat head screwdriver.

  • Pry off the linkage arm with a flat head screwdriver.

Agregar Comentario

Locate the three 13mm nuts attaching the throttle body to the intake manifold. Remove nuts with a 13mm crescent wrench. Remove nuts with a 13mm crescent wrench.
  • Locate the three 13mm nuts attaching the throttle body to the intake manifold.

  • Remove nuts with a 13mm crescent wrench.

Agregar Comentario

Lift the throttle body off of the intake manifold.
  • Lift the throttle body off of the intake manifold.

  • The manifold is now out of the engine bay and ready for cleaning or adjustment.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Raymond

Miembro Desde 11/10/10

61 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 3-28, Regan Fall 2010 Miembro de Cal Poly, Team 3-28, Regan Fall 2010

CPSU-REGAN-F10S3G28

4 Miembros

9 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 9

Todo El Tiempo: 3,573