Introducción

Use for a diagnosed wiring problem.

Partes

No se requieren partes.

Using a Torx T20 screwdriver, remove the four screws attaching the back plate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
  • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

Agregar Comentario

Remove the five screws attaching the drill handle.
  • Remove the five screws attaching the drill handle.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Remove the 4 screws attaching the front of the casing. Remove the 4 screws attaching the front of the casing.
  • Remove the 4 screws attaching the front of the casing.

Agregar Comentario

Use a multimeter set above 18V DC to check electrical connections where wires meet drill, switch, or battery terminal.
  • Use a multimeter set above 18V DC to check electrical connections where wires meet drill, switch, or battery terminal.

Agregar Comentario

Look for corrosion or burnt wires.
  • Look for corrosion or burnt wires.

  • If there are any bad connections or if there is visible damage, replace damaged wire and solder.

Agregar Comentario

  • After soldering sand off jaged solder then wrap with electrical tape

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Evan Long

Miembro Desde 15/04/10

232 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 15-48, Garner Spring 2010 Miembro de Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 8

Últimos 30 Días: 47

Todo El Tiempo: 3,922