Introducción

The speed (1-2) Switch is either stuck or won't change speed of rotation.

Partes

No se requieren partes.

Using a Torx T20 screwdriver, remove the four screws attaching the back plate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
  • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

Agregar Comentario

Remove the five screws attaching the drill handle.
  • Remove the five screws attaching the drill handle.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Remove the 4 screws attaching the front of the casing. Remove the 4 screws attaching the front of the casing.
  • Remove the 4 screws attaching the front of the casing.

Agregar Comentario

Locate small metal bar above plastic part of drill.
  • Locate small metal bar above plastic part of drill.

  • Attempt to move bar back and forth. If it wont move, try to move it while rotating the chuck. If it still will not move, there is a problem with the gears. For help see the Planetary Gear Replacement Guide

Agregar Comentario

If the bar moves, next check the small plastic switch that is numbered 1 and 2. Make sure the small tabs on the underside of the switch that move the bar are intact.
  • If the bar moves, next check the small plastic switch that is numbered 1 and 2.

  • Make sure the small tabs on the underside of the switch that move the bar are intact.

  • Replace switch as needed.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Evan Long

Miembro Desde 15/04/10

232 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 15-48, Garner Spring 2010 Miembro de Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 5

Todo El Tiempo: 3,188