Introducción

If you have any problems due to a bad motherboard, this guide will instruct you how to replace it.

Remove the 6-7.9mm ph#0 screws on the back and bottom. Remove the one 3.8mm ph#0 screw on the bottom.
  • Remove the 6-7.9mm ph#0 screws on the back and bottom.

  • Remove the one 3.8mm ph#0 screw on the bottom.

  • Remove the two 7.5mm ph#0 screws on the back and bottom.

Agregar Comentario

Remove 5.8mm ph#1 screw from the side button panel. Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.
  • Remove 5.8mm ph#1 screw from the side button panel.

  • Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.

Agregar Comentario

Pry along the seam on the top side near the buttons with a spudger. Pry along the seam on the top side near the buttons with a spudger.
  • Pry along the seam on the top side near the buttons with a spudger.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Pull the left panel away from the rest of the camcorder. Unplug the red speaker cable located at the rear of the device.
  • Pull the left panel away from the rest of the camcorder.

  • Unplug the red speaker cable located at the rear of the device.

  • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

Agregar Comentario

Pull back the plastic tabs along the edges of the motherboard. Disconnect all the cables along the left side of the motherboard.
  • Pull back the plastic tabs along the edges of the motherboard.

  • Disconnect all the cables along the left side of the motherboard.

Agregar Comentario

Disconnect all cables along the bottom of the motherboard. Pull the motherboard away from the camcorder.
  • Disconnect all cables along the bottom of the motherboard.

  • Pull the motherboard away from the camcorder.

Agregar Comentario

Desolder the two black wires holding the motherboard to the camcorder using a soldering iron.
  • Desolder the two black wires holding the motherboard to the camcorder using a soldering iron.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Oliver Adams

Miembro Desde 19/01/11

620 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 5-20, Amido Winter 2011 Miembro de Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 6

Todo El Tiempo: 2,121