Introducción

Review what the backup battery looks like, where it is, and how to replace it.

Your (actually my) PowerMac G5 the first picture is the front, the second is the side
  • Your (actually my) PowerMac G5

  • the first picture is the front, the second is the side

  • please unplug before continuing, I don't want your electocuted

Agregar Comentario

the back The bar above the gray bar is the lock lever,  lift this like in the second photo (don't worry if the layout of the back is different, the procedure is the same)
  • the back

  • The bar above the gray bar is the lock lever, lift this like in the second photo (don't worry if the layout of the back is different, the procedure is the same)

  • if the lock lever has a lock on it, take it off, I assume this is your computer so you can open it

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
while the lever is up, grip the sides of the panel and pull remove panel, you have to pull up first, then pull toward you pull the plastic guard toward you, and remove using the same method as before
  • while the lever is up, grip the sides of the panel and pull

  • remove panel, you have to pull up first, then pull toward you

  • pull the plastic guard toward you, and remove using the same method as before

  • What you are left with, if your G5 panel says G5 twice, that is ok, it only means that you have two prossessors

Agregar Comentario

Pull out the front fan assembly by putting your fingers in the groove and pulling, you may need to wiggle them a bit but they will come out Pull out the front fan assembly by putting your fingers in the groove and pulling, you may need to wiggle them a bit but they will come out
  • Pull out the front fan assembly by putting your fingers in the groove and pulling, you may need to wiggle them a bit but they will come out

Agregar Comentario

the battery is a 3 volt cr2032 made by panasonic, replace with a similar battery to yours. it faces + down on my model, but it might not on yours, so you need to check before removing to get the battery out, put your thumb under the battery, and push up while pulling the battery away from the motherboard (couldn't get a good picture of this)
  • the battery is a 3 volt cr2032 made by panasonic, replace with a similar battery to yours. it faces + down on my model, but it might not on yours, so you need to check before removing

  • to get the battery out, put your thumb under the battery, and push up while pulling the battery away from the motherboard (couldn't get a good picture of this)

    • If your battery goes ballistic and flies into the lower portion of you computer, you have to get it out or you risk permanently frying you desktop, use a magnet to remove the escaping battery

    • to reassemble you computer, follow these steps in reverse order

where is it??

Sari - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

11 personas más completaron esta guía.

Galahad

Miembro Desde 11/08/11

443 Reputación

1 Guía escrita

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 4

Últimos 7 Días: 23

Últimos 30 Días: 100

Todo El Tiempo: 9,446