Introducción

How to remove the processor from the logic board.

Pull on outer latch. Lower door until it is level with your work surface.
  • Pull on outer latch.

  • Lower door until it is level with your work surface.

  • Before working on the computer make sure it is not plugged into a power supply, then touch a metal object. This discharges static electricity, which could damage the computer.

Agregar Comentario

Use the spudger to pry the clips horizontally off of the heat sink. Fully remove the clips by lifting upwards.
  • Use the spudger to pry the clips horizontally off of the heat sink.

  • Fully remove the clips by lifting upwards.

Agregar Comentario

Remove the heat sink by pulling upwards, off of the logic board.
  • Remove the heat sink by pulling upwards, off of the logic board.

Agregar Comentario

Remove the 3 screws attaching the processor to the logic board using the Phillips #2 screwdriver. Remove processor by pulling vertically upwards.
  • Remove the 3 screws attaching the processor to the logic board using the Phillips #2 screwdriver.

  • Remove processor by pulling vertically upwards.

Agregar Comentario

Linea de Meta

11 personas más completaron esta guía.

Justin Petrilli

Miembro Desde 21/01/10

2,598 Reputación

11 Guías creadas

Equipo

Cal Poly, Team 13-24, Maness Winter 2010 Miembro de Cal Poly, Team 13-24, Maness Winter 2010

CPSU-MANESS-W10S13G24

4 Miembros

13 Guías creadas

anyone still sell the replacement processor?

Joseph Cole - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 7

Últimos 30 Días: 27

Todo El Tiempo: 10,361