Introducción

How remove the outer casing

Lay device face down on surface.
  • Lay device face down on surface.

Agregar Comentario

Heat the left and top edges with hairdryer for one minute. Move hairdryer back and forth to evenly heat up surface.
  • Heat the left and top edges with hairdryer for one minute.

  • Move hairdryer back and forth to evenly heat up surface.

  • Caution: directly heating the screen can melt or distort the screen.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Use tweezers to hold Palm right side down on it's side.
  • Use tweezers to hold Palm right side down on it's side.

  • Use a plastic opening tool to pry open front and back casing.

  • If you are unable to open you may need to heat with hairdryer for longer.

  • Be sure not to touch case directly with fingers, it will be hot!

Agregar Comentario

Leave plastic opening tools in between front and back casing.
  • Leave plastic opening tools in between front and back casing.

  • Rotate Palm and repeat steps 2 and 3 for right and back edges.

Agregar Comentario

Now pry open front and back casing with plastic opening tools. Separate front and back casing completely. Power button will fall off once front and back casing have been removed. Be sure not to lose it.
  • Now pry open front and back casing with plastic opening tools.

  • Separate front and back casing completely.

  • Power button will fall off once front and back casing have been removed. Be sure not to lose it.

Agregar Comentario

Linea de Meta

Anthony Platt

Miembro Desde 09/02/10

45 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 13-25, Maness Winter 2010 Miembro de Cal Poly, Team 13-25, Maness Winter 2010

CPSU-MANESS-W10S13G25

4 Miembros

4 Guías creadas

So...This given by my grandmother and it is out of battery. Unluckily, it won't charge, because the %#*@ old battery had gone kaput. I had a hard time finding one that might be suitable, and turnout that I need to insert it into the device and connect it to the circuit board. I have some solid soldering skills, but without a heat gun, the andonized cover won't come off. And what's more, I jammed a pencil tip into the "reset" hole when trying to reset the device. Thinking the big opening was a kind of cover-releasing button...I was just having a whole lot of trouble and thinking too much. !&&*.

Xavier Jiang - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,332