Introducción

This guide is to show you how to replace the battery on Palm Zire 71.

Flip the phone over
  • Flip the phone over

  • Slide the back cover upward to open

Agregar Comentario

Use Torx T5 screwdriver to remove the top screws
  • Use Torx T5 screwdriver to remove the top screws

Agregar Comentario

Remove the back sticker
  • Remove the back sticker

  • Remove the bottom Philips #00 screws

Agregar Comentario

Turn to the frontside Slide the screen upward a little higher WITHOUT detaching the screen
  • Turn to the frontside

  • Slide the screen upward a little higher WITHOUT detaching the screen

  • Use the plastic opening tool to pry off the front panel

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Remove the bottom Philips #00 screws Remove the bracket
  • Remove the bottom Philips #00 screws

  • Remove the bracket

  • Use the plastic opening tool to pry off the speaker

Agregar Comentario

Slide the back cover off Slide the back cover off
  • Slide the back cover off

Agregar Comentario

Remove the Philips #00 screw
  • Remove the Philips #00 screw

  • Remove the sliver metal piece

Agregar Comentario

Remove the Philips screws #00 Remove the rear blue panel by prying both sides using the plastic opening tool
  • Remove the Philips screws #00

  • Remove the rear blue panel by prying both sides using the plastic opening tool

Agregar Comentario

Remove the black plastic sticker Pull the tap up to remove the metal cap Pull the tap up to remove the metal cap
  • Remove the black plastic sticker

  • Pull the tap up to remove the metal cap

Agregar Comentario

Remove the cable by pinching the sides and pulling Pry off the battery with the plastic opening tool Insert the new battery
  • Remove the cable by pinching the sides and pulling

  • Pry off the battery with the plastic opening tool

  • Insert the new battery

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Jinxian Jiang

Miembro Desde 28/04/11

11 Reputación

6 Guías creadas

Equipo

It's clear they just want you to throw it away when the battery dies. That was quite a chore getting the parts off and such without destroying the circuit board and that fine ribbon cable. Got it done though. No wifi I see. Too bad.

dnphoton - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 3

Últimos 30 Días: 11

Todo El Tiempo: 6,650