Introducción

Use this guide to replace the back cover.

Remove the four 3.0mm screws on the bottom of the camera.
  • Remove the four 3.0mm screws on the bottom of the camera.

Agregar Comentario

Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.
  • Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.

Agregar Comentario

Remove the two 3.0mm screws on the right side of the camera.
  • Remove the two 3.0mm screws on the right side of the camera.

Agregar Comentario

Carefully open the back cover. Take care as there are connectors still attached.
  • Carefully open the back cover. Take care as there are connectors still attached.

Agregar Comentario

Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.
  • Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.

Agregar Comentario

Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.
  • Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.

  • The back cover will be disconnected from the camera

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Kaky Payne

Miembro Desde 17/04/12

58 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 12-38, Regan Spring 2012 Miembro de Cal Poly, Team 12-38, Regan Spring 2012

CPSU-REGAN-S12S12G38

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 5

Todo El Tiempo: 886