Introducción

The ball bearing ring allows the rotation of the top half of the Nexus Q. This allows the user to change the volume. The ring may have problems rotating smoothly due to particles and dust residue.

Squeeze and pull the cap to remove it from the Nexus Q.
  • Squeeze and pull the cap to remove it from the Nexus Q.

Agregar Comentario

Use a spudger to disconnect the Taoglas Wi-Fi Dual Band Antenna.
  • Use a spudger to disconnect the Taoglas Wi-Fi Dual Band Antenna.

Agregar Comentario

Undo the ZIF connector by prying it with a spudger.
  • Undo the ZIF connector by prying it with a spudger.

Agregar Comentario

Use a Phillips #0 screwdriver to unscrew the four 1.3 mm screws.
  • Use a Phillips #0 screwdriver to unscrew the four 1.3 mm screws.

  • After removing the screws, there will be two parts. The top part contains the daughterboard. Store it safely. It will not be used.

Agregar Comentario

View the bottom half of the Nexus Q.
  • View the bottom half of the Nexus Q.

  • Use a Phillips #0 screwdriver to remove the four 0.8 mm screws holding the ball bearing ring in place.

Agregar Comentario

Remove the ball bearing ring.
  • Remove the ball bearing ring.

  • When placing a new ring in its place, make sure to orient it right or the top will not close.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Taewan Kim

Miembro Desde 31/01/13

22 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 7-10, Maness Winter 2013 Miembro de Cal Poly, Team 7-10, Maness Winter 2013

CPSU-MANESS-W13S7G10

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 412