Introducción

This guide is for removing the screen for the Motorola V551. A flat dental tool may be helpful for step 5 but is not necessary.

Using a spudger, remove the four rubber covers from over the screws. Using a spudger, remove the four rubber covers from over the screws. Using a spudger, remove the four rubber covers from over the screws.
  • Using a spudger, remove the four rubber covers from over the screws.

Agregar Comentario

Unscrew the cover screws using the T6 bit
  • Unscrew the cover screws using the T6 bit

Agregar Comentario

Loosen and remove the cover with a plastic opening tool. Loosen and remove the cover with a plastic opening tool.
  • Loosen and remove the cover with a plastic opening tool.

Agregar Comentario

Gently loosen the protective cover with the plastic opening tool. Gently loosen the protective cover with the plastic opening tool.
  • Gently loosen the protective cover with the plastic opening tool.

Do not pry from the top or bottom of the metal cover. There are a pair of 1/4" long openings on either side of the metal cover at the midpoint of the case. The plastic teeth which lock into the openings must be withdrawn. I used the point of cuticle sissors to get behind the metal strip under each tooth and pull outwards a small distance to release each tooth. The sides of the cover will spring up.

Fonce - Contestar

Carefully remove the protective cover from the circuitry Slowly peel the black rubber gasket up off the circuit board. Carefully move the camera out of the way using your hand.
  • Carefully remove the protective cover from the circuitry

  • Slowly peel the black rubber gasket up off the circuit board.

  • Carefully move the camera out of the way using your hand.

  • Use a flat tool to separate the connection between the upper and lower circuit boards.

Agregar Comentario

Gently slip the copper strip out from under the circutry by hand. Gently slip the copper strip out from under the circutry by hand. Gently slip the copper strip out from under the circutry by hand.
  • Gently slip the copper strip out from under the circutry by hand.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

gregatron

Miembro Desde 29/10/09

72 Reputación

12 Guías creadas

Equipo

Cal Poly, Team 6-6, Maness Fall 2009 Miembro de Cal Poly, Team 6-6, Maness Fall 2009

CPSU-MANESS-F09S6G6

4 Miembros

12 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 6

Últimos 30 Días: 7

Todo El Tiempo: 3,506