Introducción

Replacing the screen and connector ribbon.

Partes

No se requieren partes.

Pull at top of faceplate, and it will pop off.
  • Pull at top of faceplate, and it will pop off.

Agregar Comentario

Unscrew four screws on front cover.
  • Unscrew four screws on front cover.

Agregar Comentario

Slide out metallic silver cover.
  • Slide out metallic silver cover.

  • This piece is wedged in tight. Try to slide out one hook at a time, instead of both simultaneously.

Agregar Comentario

Use a tool to wedge in between the silver and black parts on the cover.
  • Use a tool to wedge in between the silver and black parts on the cover.

  • Silver part should now snap off.

Agregar Comentario

Black rubber part may now be easily removed.
  • Black rubber part may now be easily removed.

Agregar Comentario

Use a soldering iron to disconnect the connector ribbon from the phone.
  • Use a soldering iron to disconnect the connector ribbon from the phone.

Agregar Comentario

Locate the four screws on the back of the phone. Using your T6 Torx Screwdriver, unscrew these screws. Remove the SIM card located on the back of the phone.
  • Locate the four screws on the back of the phone.

  • Using your T6 Torx Screwdriver, unscrew these screws.

  • Remove the SIM card located on the back of the phone.

  • A ribbon near the antenna is still attached to the motherboard. Do not break this ribbon.

Agregar Comentario

Unclip the pronged rectangle connector ribbon attached to the motherboard. Remove the motherboard.
  • Unclip the pronged rectangle connector ribbon attached to the motherboard.

  • Remove the motherboard.

Agregar Comentario

Now that the ribbon is loose, the screen (white part) can swing away. Some of the black "tape" can be peeled back, but the screen is still attached.  More work may be required to fully separate this part.
  • Now that the ribbon is loose, the screen (white part) can swing away.

  • Some of the black "tape" can be peeled back, but the screen is still attached. More work may be required to fully separate this part.

Agregar Comentario

Slide out the part of the connector ribbon that was just attached to the motherboard through this narrow slot in the phone. This is a tight fit.  Be careful to not tear the ribbon while maneuvering it through this slot.
  • Slide out the part of the connector ribbon that was just attached to the motherboard through this narrow slot in the phone.

  • This is a tight fit. Be careful to not tear the ribbon while maneuvering it through this slot.

  • The entire connector ribbon unit can now be removed from the phone.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Tyler Knisley

Miembro Desde 07/05/10

1 Reputación

14 Guías creadas

Equipo

Cal Poly, Team 6-16, Maness Spring 2010 Miembro de Cal Poly, Team 6-16, Maness Spring 2010

CPSU-MANESS-S10S6G16

4 Miembros

14 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 1

Todo El Tiempo: 3,133