Introducción

Replace the main logic board for your Motorola MOTO phone.

Partes

No se requieren partes.

Using your finger, press down on the clip holding the back cover on Pull the back cover off.
  • Using your finger, press down on the clip holding the back cover on

  • Pull the back cover off.

Agregar Comentario

Place thumb and index finger in the spaces on either side of the battery. Pull battery out.
  • Place thumb and index finger in the spaces on either side of the battery.

  • Pull battery out.

Agregar Comentario

Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.
  • Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.

Agregar Comentario

Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver
  • Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad

  • Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver

Agregar Comentario

Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone. Slide the opening tool around the phone clockwise until you reach the audio port. Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.
  • Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone.

  • Slide the opening tool around the phone clockwise until you reach the audio port.

  • Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.

Agregar Comentario

Remove the plastic covering completely from the body of the phone.
  • Remove the plastic covering completely from the body of the phone.

Agregar Comentario

Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile. Remove the main logic board.
  • Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile.

  • Remove the main logic board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

C Miller

Miembro Desde 25/06/12

38 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 1-3, Regan SU 2012 Miembro de Cal Poly, Team 1-3, Regan SU 2012

CPSU-REGAN-SU12S1G3

2 Miembros

14 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 6

Todo El Tiempo: 1,267