Introducción

A guide to replace the antenna.

Partes

No se requieren partes.

Turn the phone on its back. Turn the phone on its back.
  • Turn the phone on its back.

Agregar Comentario

Orient the phone as shown. Remove the battery cover by pushing upward with your thumb.
  • Orient the phone as shown.

  • Remove the battery cover by pushing upward with your thumb.

Agregar Comentario

Place your fingernail at the top of the battery and pry the battery out towards you. Place your fingernail at the top of the battery and pry the battery out towards you.
  • Place your fingernail at the top of the battery and pry the battery out towards you.

Agregar Comentario

Orient the phone as shown with the battery already removed.
  • Orient the phone as shown with the battery already removed.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards. Use a Phillips #00 screwdriver to remove the 5 screws as shown here. Use a Phillips #00 screwdriver to remove the 5 screws as shown here.
  • Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards.

  • Use a Phillips #00 screwdriver to remove the 5 screws as shown here.

Agregar Comentario

Place an iPod opener tool in the seam above the antenna. Run the tool around the perimeter of the entire phone. Run the tool around the perimeter of the entire phone.
  • Place an iPod opener tool in the seam above the antenna.

  • Run the tool around the perimeter of the entire phone.

Agregar Comentario

Check to see that your device looks like the attached photo.
  • Check to see that your device looks like the attached photo.

Agregar Comentario

Locate the screw and copper fixture that hold the antenna in place.
  • Locate the screw and copper fixture that hold the antenna in place.

  • Remove the screw from the device using a Philips #00 screwdriver.

Agregar Comentario

Remove the copper fixture after it has been unscrewed. Remove the copper fixture after it has been unscrewed.
  • Remove the copper fixture after it has been unscrewed.

Agregar Comentario

Check to see that your device looks like the attached photo. Check to see that your device looks like the attached photo.
  • Check to see that your device looks like the attached photo.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Douglas Blaalid

Miembro Desde 13/01/10

282 Reputación

15 Guías creadas

Equipo

Cal Poly, Team 4-13, Forte Winter 2010 Miembro de Cal Poly, Team 4-13, Forte Winter 2010

CPSU-FORTE-W10S4G13

5 Miembros

15 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 2,297