Introducción

BEFORE STARTING, note that this repair guide requires soldering experience!

Turn off the cellphone by pressing down on the red "END" button for 3 seconds. Flip cellphone over and press up on the gray sliding mechanism towards the top of the phone. At the same time, pull on the large silver battery and it should come right off.
  • Turn off the cellphone by pressing down on the red "END" button for 3 seconds.

  • Flip cellphone over and press up on the gray sliding mechanism towards the top of the phone. At the same time, pull on the large silver battery and it should come right off.

Agregar Comentario

Using the spudger, carefully push off the gray caps as shown. Use the Philips screwdriver to remove the screws underneath the gray caps. Use the Philips screwdriver to remove the screws underneath the gray caps.
  • Using the spudger, carefully push off the gray caps as shown.

  • Use the Philips screwdriver to remove the screws underneath the gray caps.

Agregar Comentario

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Locate the small gap at the top right corner of the phone as shown. Use the spudger to gently pry the back casing off. The spudger can dent the casing if too much force is applied.
  • Locate the small gap at the top right corner of the phone as shown. Use the spudger to gently pry the back casing off.

  • The spudger can dent the casing if too much force is applied.

Agregar Comentario

Remove the speaker using the sharp end of the spudger. Removing the speaker may require more effort if the speaker is stuck to the phone.
  • Remove the speaker using the sharp end of the spudger. Removing the speaker may require more effort if the speaker is stuck to the phone.

  • Notice that the speaker and the logic board for the screen are connected by a red and black wire. This will be important for the next step.

Agregar Comentario

This step will require  soldering experience. Desolder the connection between the logic board screen and the black wire.
  • This step will require soldering experience.

  • Desolder the connection between the logic board screen and the black wire.

  • Desolder the connection between the logic board screen and the red wire.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Matthew Castillo

Miembro Desde 21/04/10

1 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 34-58, Forte Spring 2010 Miembro de Cal Poly, Team 34-58, Forte Spring 2010

CPSU-FORTE-S10S34G58

5 Miembros

9 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,231