Introducción

Use this guide to replace the brush in the head of the vacuum.

Place the vacuum on its back. On the bottom right side, push the red lever to the left.
  • Place the vacuum on its back.

  • On the bottom right side, push the red lever to the left.

  • Remove the plastic cover.

Agregar Comentario

Grab the red switch under the brush and push left. Then remove the plastic base plate. Then remove the plastic base plate.
  • Grab the red switch under the brush and push left.

  • Then remove the plastic base plate.

Agregar Comentario

MANTA DRIVER KIT
112 bit driver kit $59.99
MANTA DRIVER KIT
112 bit driver kit $59.99
Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush. Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush. Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush.
  • Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush.

Agregar Comentario

Remove the two screws on the left side of the brush. Remove the two screws on the left side of the brush. Remove the two screws on the left side of the brush.
  • Remove the two screws on the left side of the brush.

Agregar Comentario

Pull the clear plastic away from the head of the vacuum. Slide the belt off the metal rod with your finger. Pull the brush free.
  • Pull the clear plastic away from the head of the vacuum.

  • Slide the belt off the metal rod with your finger.

  • Pull the brush free.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Erik Ingels

Miembro Desde 18/01/18

193 Reputación

2 Guías creadas

Equipo

Cal Poly, Team S12-G4, Banghart Winter 2018 Miembro de Cal Poly, Team S12-G4, Banghart Winter 2018

CPSU-BANGHART-W18S12G4

5 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 20

Todo El Tiempo: 29