Repara tus cosas Comunidad Tienda

Havoc Heli IR LED Replacement

Introducción

Before beginning this repair, you should be familiar with soldering a circuit board. The soldering skills needed aren't very in-depth, but you'll be working very close to some other components.

Qué necesitas

  1. Havoc Heli IR LED Replacement, Havoc Heli IR LED: paso 1, imagen 1 de 2 Havoc Heli IR LED Replacement, Havoc Heli IR LED: paso 1, imagen 2 de 2

    • Power off the controller before disassembly.

    • Place a small piece of tape over the Light button to prevent it from falling out in later steps.

    • Flip the controller over so the back is facing up.

    Editar

  2. Havoc Heli IR LED Replacement: paso 2, imagen 1 de 3 Havoc Heli IR LED Replacement: paso 2, imagen 2 de 3 Havoc Heli IR LED Replacement: paso 2, imagen 3 de 3

    • Remove the battery compartment screw with a small Phillips screw driver.

    • Lift off the battery cover.

    • Remove the six AA batteries from the compartment.

    Editar

  4. Havoc Heli IR LED Replacement: paso 3, imagen 1 de 3 Havoc Heli IR LED Replacement: paso 3, imagen 2 de 3 Havoc Heli IR LED Replacement: paso 3, imagen 3 de 3

    • Remove the remaining four screws with a small Phillips screw driver.

    • Flip the device over so the front is facing up.

    • Remove the front cover and place it to the left side.

    • Make sure to note the locations of the joysticks and other controls in case they fall out of place during this or future steps.

    Editar

  5. Havoc Heli IR LED Replacement: paso 4, imagen 1 de 1

    • Lift up the red IR LED cover to remove it.

    Editar

  6. Havoc Heli IR LED Replacement: paso 5, imagen 1 de 2 Havoc Heli IR LED Replacement: paso 5, imagen 2 de 2

    • Use the soldering iron and solder wick to remove the solder from the IR LED you're replacing.

    • Pull the LED out through the top.

    Editar

  7. Havoc Heli IR LED Replacement: paso 6, imagen 1 de 2 Havoc Heli IR LED Replacement: paso 6, imagen 2 de 2

    • Insert the new LED into the slot.

    • Make sure that the short lead of the LED is on the right.

    • Use the soldering iron and solder to connect the new LED.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 2 otros colaboradores

Michael Kent

Miembro Desde 03/30/16

128 Reputación

1 Guía escrita

Insignias: 4

+1 mas insignia

Equipo

Michigan Tech, Team 1-13, Lauer Fall 2016 Miembro de Michigan Tech, Team 1-13, Lauer Fall 2016

MTU-LAUER-F16S1G13

1 Miembro

1 Guía escrita

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 11

Todo El Tiempo: 526