Slide the silver release tab up and simultaneously lift the cover up from the left side.
  • Slide the silver release tab up and simultaneously lift the cover up from the left side.

Agregar Comentario

Push the tab from left to right to remove the cover.
  • Push the tab from left to right to remove the cover.

Agregar Comentario

Now lift the battery up and away from the device to remove it.
  • Now lift the battery up and away from the device to remove it.

Agregar Comentario

Remove the four silver screws (T5 x .25 in).
  • Remove the four silver screws (T5 x .25 in).

Agregar Comentario

Remove the single black screw (T5 x .125 in) beneath the HP sticker.
  • Remove the single black screw (T5 x .125 in) beneath the HP sticker.

Agregar Comentario

Next, use your plastic removal tool to separate the gray back from the black center piece. For better results, start the separation at the corner piece.
  • Next, use your plastic removal tool to separate the gray back from the black center piece.

  • For better results, start the separation at the corner piece.

Agregar Comentario

Remove the back case.
  • Remove the back case.

Agregar Comentario

Now that the back cover is removed, remove the small screw (#00 Philips x .17) to the left of the SD card slot
  • Now that the back cover is removed, remove the small screw (#00 Philips x .17) to the left of the SD card slot

Agregar Comentario

Next you will need to unlock and remove the ribbon cable Carefully pull back on both sides of the brown bar using metal tweezers, unlocking the cable and slipping it out of the connector
  • Next you will need to unlock and remove the ribbon cable

  • Carefully pull back on both sides of the brown bar using metal tweezers, unlocking the cable and slipping it out of the connector

  • The bar, connector, and cable are fragile components that can be easily broken

Agregar Comentario

Next you need to remove the wire off the bottom of the mother board The easiest method is to use some metal tweezers and grip the plug close to the connector.
  • Next you need to remove the wire off the bottom of the mother board

  • The easiest method is to use some metal tweezers and grip the plug close to the connector.

  • Make sure all these connections are properly disconnected before separation of the motherboard

Agregar Comentario

Next use your plastic removal tool and separate the silver front case from the black frame.
  • Next use your plastic removal tool and separate the silver front case from the black frame.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

John Pagliero

Miembro Desde 27/01/11

886 Reputación

7 Guías creadas

Equipo

Cal Poly, Team 3-39, Regan Winter 2011 Miembro de Cal Poly, Team 3-39, Regan Winter 2011

CPSU-REGAN-W11S3G39

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,175