Introducción

Replacing the WWAN (Wireless Wide Area Network) card is easy and straightforward.

Turn off and unplug the netbook before replacing the battery. Hold the netbook top-side down with the lid closed.
  • Turn off and unplug the netbook before replacing the battery.

  • Hold the netbook top-side down with the lid closed.

  • Slide the plastic battery release latches towards the lock symbols.

  • The left tab unlocks completely, but you will need to hold the right tab towards the lock symbol as you remove the battery.

Agregar Comentario

Slide the battery out from the netbook.
  • Slide the battery out from the netbook.

Agregar Comentario

Turn the netbook to view its edge.
  • Turn the netbook to view its edge.

  • Press both orange eject buttons simultaneously, and use a spudger to pry off the back case.

Agregar Comentario

If the back case does not separate from the netbook easily, use the spudger to pry off the back case by the edge near the battery compartment, and work your way to the sides. The case will then pivot along the front edge.
  • If the back case does not separate from the netbook easily, use the spudger to pry off the back case by the edge near the battery compartment, and work your way to the sides. The case will then pivot along the front edge.

Agregar Comentario

Pull the back case off from the front edge.
  • Pull the back case off from the front edge.

Agregar Comentario

Use a plastic opening tool to disconnect the two gold antenna cables from the WWAN card. Use a plastic opening tool to disconnect the two gold antenna cables from the WWAN card.
  • Use a plastic opening tool to disconnect the two gold antenna cables from the WWAN card.

Agregar Comentario

Use a phillips #00 screwdriver to remove the 2 phillips 2.0 and 3.0 mm screws that secure the WWAN to the system board. Use a phillips #00 screwdriver to remove the 2 phillips 2.0 and 3.0 mm screws that secure the WWAN to the system board.
  • Use a phillips #00 screwdriver to remove the 2 phillips 2.0 and 3.0 mm screws that secure the WWAN to the system board.

Agregar Comentario

Remove the WWAN by pulling or Slide away the WWAN card out of its slot at an angle.
  • Remove the WWAN by pulling or Slide away the WWAN card out of its slot at an angle.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Heather Freed

Miembro Desde 06/10/12

582 Reputación

8 Guías creadas

Equipo

Cal Poly, Team 9-17, Amido Fall 2012 Miembro de Cal Poly, Team 9-17, Amido Fall 2012

CPSU-AMIDO-F12S9G17

3 Miembros

8 Guías creadas

apakah benda tersebut ada dalam paket penjualan, atau dijual terpisah?

rioarayana - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 18

Últimos 30 Días: 62

Todo El Tiempo: 4,296