Introducción

Before you begin disassembling the device, be sure the power is off. For this guide you will need to know how to use a soldering iron. For help with soldering look at this guide.

Wedge a plastic opening tool in between the outer frame and the rear panel assembly. Pry the outer frame off the perimeter of the rear panel assembly.
  • Wedge a plastic opening tool in between the outer frame and the rear panel assembly.

  • Pry the outer frame off the perimeter of the rear panel assembly.

  • The cover will easily pop off.

Agregar Comentario

Remove the four #00 Phillips screws securing the front case assembly to the rear case assembly. Carefully lift, but do not completely separate, the front case assembly from the rear case assembly.
  • Remove the four #00 Phillips screws securing the front case assembly to the rear case assembly.

  • Carefully lift, but do not completely separate, the front case assembly from the rear case assembly.

  • Be extremely cautious when separating both halves, as the rear case assembly is still attached to the front case assembly via a few connectors.

Agregar Comentario

Gently pull the battery cable connector from its socket on the motherboard.
  • Gently pull the battery cable connector from its socket on the motherboard.

  • The second connector can remain attached to the motherboard, but be careful not to break the connector while handling both halves of the device.

Agregar Comentario

Guía de regalos para el día del padre
Honremos a más que nuestros padres—celebremos a todos los mentores que nos enseñaron a reparar.
Guía de regalos para el día del padre
Honremos a aquellos que nos enseñaron a reparar.
Do not disconnect the black wire. Doing so may cause severe damage to your device.
  • Do not disconnect the black wire. Doing so may cause severe damage to your device.

  • Remove the two #00 Phillips screws securing the battery to the rear case assembly.

Agregar Comentario

Use a plastic opening tool to peel back the battery bracket. Cautiously grasp the battery and lift it out of the device.
  • Use a plastic opening tool to peel back the battery bracket.

  • Cautiously grasp the battery and lift it out of the device.

Agregar Comentario

The speakers are nestled along the sides of the rear case assembly.
  • The speakers are nestled along the sides of the rear case assembly.

Agregar Comentario

Carefully heat and desolder the speaker lead wires from the back of each individual speaker.
  • Carefully heat and desolder the speaker lead wires from the back of each individual speaker.

  • The speaker lead wires are the white and brown wires.

  • For help with soldering check out this guide.

Agregar Comentario

Use the flat edge of a spudger to pry each speaker from its housing in the rear case assembly.
  • Use the flat edge of a spudger to pry each speaker from its housing in the rear case assembly.

  • The speaker lead wires are still attached to the speaker, however they should have been desoldered in the previous step.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Arturo Barajas

Miembro Desde 18/01/12

11 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 11-19, Maness Winter 2012 Miembro de Cal Poly, Team 11-19, Maness Winter 2012

CPSU-MANESS-W12S11G19

4 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 1

Todo El Tiempo: 993