Repara tus cosas Comunidad Tienda

Garmin Nuvi 680 Antenna Replacement

Introducción

A step-by-step guide to replacing the antenna in the Garmin Nuvi 680.

Qué necesitas

  1. Garmin Nuvi 680 Antenna Replacement, Outer Case: paso 1, imagen 1 de 1

    • Flip open the antenna on the back of the device.

    • Remove the two 4.42 mm screws on the antenna cover using a T5 Torx screwdriver.

    Traducir

  2. Garmin Nuvi 680 Antenna Replacement: paso 2, imagen 1 de 1

    • Remove the antenna cover.

    Traducir

  3. Garmin Nuvi 680 Antenna Replacement: paso 3, imagen 1 de 1

    • The yellow wire is connected to the motherboard, so you cannot disconnect it until you finish opening the device.

    • Pull the antenna circuit board out of its case.

    Traducir

  5. Garmin Nuvi 680 Antenna Replacement: paso 4, imagen 1 de 2 Garmin Nuvi 680 Antenna Replacement: paso 4, imagen 2 de 2

    • Insert the pointed end of a spudger into the leftmost slit of the antenna case.

    • Push the spudger to the right.

    • Slide the antenna case out slowly or you may lose the antenna's spring. The spring is inside the black plastic that holds the antenna case to the device.

    • Slide the antenna case out of the device.

    • Reinstallation tip: first reassemble the antenna casing (place antenna back into its plastic cover), and then re-insert the entire assembly back into the GPS body.

    Traducir

  6. Garmin Nuvi 680 Antenna Replacement: paso 5, imagen 1 de 1

    • Remove the two screws on the back of the outer case using a T5 Torx screwdriver.

    • These screws are 10.82 mm long.

    Traducir

  7. Garmin Nuvi 680 Antenna Replacement: paso 6, imagen 1 de 2 Garmin Nuvi 680 Antenna Replacement: paso 6, imagen 2 de 2

    • Gently pull apart the front and back of the device. The front and back are still connected by ribbon cables.

    • Starting along the top, separate the front and back of the device by pushing an iPod-opening tool into the crack along each side of the case.

    Traducir

  8. Garmin Nuvi 680 Antenna Replacement, Antenna: paso 7, imagen 1 de 2 Garmin Nuvi 680 Antenna Replacement, Antenna: paso 7, imagen 2 de 2

    • Use a spudger to disconnect the yellow antenna wire from the ZIF connector by opening the brown latch holding the wire in place.

    • Remove the antenna.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 7 otros colaboradores

Chris Marzano

Miembro Desde 01/20/11

968 Reputación

6 Guías creadas

Insignias: 14

+ 11 más insignias

Equipo

Cal Poly, Team 5-22, Amido Winter 2011 Miembro de Cal Poly, Team 5-22, Amido Winter 2011

CPSU-AMIDO-W11S5G22

5 Miembros

7 Guías creadas

Un comentario

Where can you find the replacment antenna?

All I see is external antennas on the net.

Dennis - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 3

Todo El Tiempo: 4,440