Introducción

Opening the Nuvi and replacing a broken/damaged display.

Partes

No se requieren partes.

Peel off the sticker from the bottom of the device to reveal two screws. Peel off the sticker from the bottom of the device to reveal two screws.
  • Peel off the sticker from the bottom of the device to reveal two screws.

Agregar Comentario

Remove two T5 Torx screws.
  • Remove two T5 Torx screws.

Agregar Comentario

Insert a plastic opening tool in the gap between the front and rear casing. Carefully work the tool around the gap, separating the two halves of the case.
  • Insert a plastic opening tool in the gap between the front and rear casing.

  • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

Agregar Comentario

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Apply pressure to the tabs holding the screen in place with the plastic opening tool
  • Apply pressure to the tabs holding the screen in place with the plastic opening tool

Agregar Comentario

Apply pressure to the same tabs again to remove the front of the screen. Apply pressure to the same tabs again to remove the front of the screen.
  • Apply pressure to the same tabs again to remove the front of the screen.

Agregar Comentario

Peel away the material holding the ribbon cable in place. Peeling the sticker halfway will allow you to access the ribbon cable. Removing it fully will allow you to detach the upper case from the lower case.
  • Peel away the material holding the ribbon cable in place.

  • Peeling the sticker halfway will allow you to access the ribbon cable. Removing it fully will allow you to detach the upper case from the lower case.

Agregar Comentario

Disconnect the ribbon cable from the logic board. Make sure to disconnect the cable from both ports.
  • Disconnect the ribbon cable from the logic board.

    • Make sure to disconnect the cable from both ports.

Agregar Comentario

The display consists of two screens which are held together by the ribbon. The display consists of two screens which are held together by the ribbon.
  • The display consists of two screens which are held together by the ribbon.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Nick

Miembro Desde 11/04/10

7 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 25-90, Amido Spring 2010 Miembro de Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 Miembros

9 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 2

Últimos 7 Días: 7

Últimos 30 Días: 21

Todo El Tiempo: 10,400