Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.
  • Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.

Agregar Comentario

Locate the gray base support release tabs found on either side pictured in the first image. There are release tabs on each side of the base.
  • Locate the gray base support release tabs found on either side pictured in the first image.

    • There are release tabs on each side of the base.

  • Press both release tabs in with the tip of your fingers and pull the gray base support until the tabs are cleared.

Agregar Comentario

Continue removing the gray base support by pressing your thumb into the circular opening in the base and pulling with your figures on the back side.
  • Continue removing the gray base support by pressing your thumb into the circular opening in the base and pulling with your figures on the back side.

  • Notice that on the internal front tip of the base there is a tab. Because of this tab the back end will pivot off at that point.

Agregar Comentario

After the base has separated more it will be easy to fully remove it. Continue pulling the back edge of the gray base support, rotating it around the front tab until it comes off completely.
  • After the base has separated more it will be easy to fully remove it. Continue pulling the back edge of the gray base support, rotating it around the front tab until it comes off completely.

Agregar Comentario

Remove the following five 14.5 mm Phillips #1 screws found on the bottom.
  • Remove the following five 14.5 mm Phillips #1 screws found on the bottom.

    • All of the screws are recessed by 17.5 mm, so ensure your screwdriver can reach that far.

Agregar Comentario

Once all five screws have been removed the base cover should fall right off with out any effort.
  • Once all five screws have been removed the base cover should fall right off with out any effort.

  • When putting the base cover back on; be careful to make sure that none of the wires are pinched.

Agregar Comentario

Remove the two 10 mm Phillips #1 screws found connecting the switch to the case.
  • Remove the two 10 mm Phillips #1 screws found connecting the switch to the case.

  • Notice the AC power cord line (white wire) goes into the switch under the [Off] button

Agregar Comentario

Take the 1.5 mm Flathead Screwdriver, or any thin elongated tool that fits into the semi-circular holes along side the wires. Press into the hole gently to release the grip on the wires.
  • Take the 1.5 mm Flathead Screwdriver, or any thin elongated tool that fits into the semi-circular holes along side the wires. Press into the hole gently to release the grip on the wires.

    • The wires should release with ease if done properly.

  • When reassembling; skip this step.

Agregar Comentario

Take the new switch, and simply push the wiring into the correct holes:
  • Take the new switch, and simply push the wiring into the correct holes:

    • AC Power Cord (white wire)

    • Low speed (gray wire)

    • Medium speed (orange wire)

    • High speed (red wire)

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Alan Su

Miembro Desde 03/10/12

513 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 24-28, Regan Fall 2012 Miembro de Cal Poly, Team 24-28, Regan Fall 2012

CPSU-REGAN-F12S24G28

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 4

Últimos 30 Días: 53

Todo El Tiempo: 1,866