Introducción

If the speaker is dead or blown, install a new one.

Be sure to unplug the device before proceeding.
  • Be sure to unplug the device before proceeding.

  • Use a Phillips #0 screwdriver to remove the four 21.7mm screws holding the back panel to the frame.

Agregar Comentario

Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.
  • Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.

Agregar Comentario

Once the top is separated, use your hand to remove the back panel from the unit.
  • Once the top is separated, use your hand to remove the back panel from the unit.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Using tape or a post-it, label the input and output wires on the reverb. Remove these wires from the box.
  • Using tape or a post-it, label the input and output wires on the reverb. Remove these wires from the box.

Agregar Comentario

Remove the two female connection terminals from the speaker terminals.
  • Remove the two female connection terminals from the speaker terminals.

Agregar Comentario

Use a Philips #1 screwdriver to remove the four 21.9 mm Phillips screws from the perimeter of the speaker.
  • Use a Philips #1 screwdriver to remove the four 21.9 mm Phillips screws from the perimeter of the speaker.

Agregar Comentario

Gently remove the speaker. Gently remove the speaker.
  • Gently remove the speaker.

Agregar Comentario

Conclusión

To install the new speaker, follow the instructions given in reverse.

Equipo

Cal Poly, Team 24-30, Regan Fall 2012 Miembro de Cal Poly, Team 24-30, Regan Fall 2012

CPSU-REGAN-F12S24G30

5 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 6

Últimos 30 Días: 46

Todo El Tiempo: 5,160