Repara tus cosas Comunidad Tienda

Disassembling Sony Ericsson w600i Back Housing

Introducción

This disassembly prerequisite is required to access most components in the phone, as the swivel assembly also secures the display section to its housing.

Qué necesitas

  1. Disassembling Sony Ericsson w600i Back Housing, Disassembling Sony Ericsson w600i Battery Cover: paso 1, imagen 1 de 1

    • Grip the lower portion of the back of the phone and slide downwards.

    Traducir

  2. Disassembling Sony Ericsson w600i Back Housing, Battery: paso 2, imagen 1 de 1

    • Lift battery at the rounded notch near the bottom of the phone.

    Traducir

  3. Disassembling Sony Ericsson w600i Back Housing, Back housing: paso 3, imagen 1 de 1

    • Unscrew the four Torx screws from the backplate.

    • The backplate may begin to separate from the keypad face. Do not try to remove it yet.

    • The screws are T5 Torx screws, 5.6mm.

    Traducir

  4. Disassembling Sony Ericsson w600i Back Housing: paso 4, imagen 1 de 1

    • Swivel the phone open.

    Traducir

  6. Disassembling Sony Ericsson w600i Back Housing: paso 5, imagen 1 de 1

    • Using the Spudger, gently pry up the U-shaped grey cover below the keypad.

    • The cover is secured with adhesive tape. The gentler this is removed, the easier it will be to reassemble.

    Traducir

  7. Disassembling Sony Ericsson w600i Back Housing: paso 6, imagen 1 de 1

    • Remove the two Torx screws from below the cover.

    • These are T5 Torx screws, 8.6mm.

    Traducir

  8. Disassembling Sony Ericsson w600i Back Housing: paso 7, imagen 1 de 1

    • Gently work a spudger or a fingernail between the keypad face and the backplate.

    • The pieces are clipped together most tightly at the bottom loop section.

    Traducir

  9. Disassembling Sony Ericsson w600i Back Housing: paso 8, imagen 1 de 2 Disassembling Sony Ericsson w600i Back Housing: paso 8, imagen 2 de 2

    • Separate the keypad face from the backplate.

    • The keypad keys and the button component are both loose inside the phone, so take note of their orientation in case they become dislodged.

    • Take note of the braided cord's state. Upon reassembly it should be returned to the same orientation.

    Traducir

  10. Disassembling Sony Ericsson w600i Back Housing: paso 9, imagen 1 de 3 Disassembling Sony Ericsson w600i Back Housing: paso 9, imagen 2 de 3 Disassembling Sony Ericsson w600i Back Housing: paso 9, imagen 3 de 3

    • Holding the backplate away from the swivel, remove the 4 small Phillips screws and both stamped struts from the swivel assembly.

    • Note that only the bottom strut has a tab.

    • The screws are Phillips, 2.9mm

    Traducir

  11. Disassembling Sony Ericsson w600i Back Housing: paso 10, imagen 1 de 1

    • The back housing is now disassembled, and the swivel assembly is revealed.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 3 otros colaboradores

Beau Blanchard

Miembro Desde 09/30/12

20 Reputación

6 Guías creadas

Insignias: 5

+ 2 más insignias

Equipo

University of Maine, Team 1-5, Diaz Fall 2012 Miembro de University of Maine, Team 1-5, Diaz Fall 2012

UMAINE-DIAZ-F12S1G5

1 Miembro

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 3

Todo El Tiempo: 429