Introducción

This will guide you on how to disassemble the Palm Centro to get to the logic board.

Partes

No se requieren partes.

Press and slide open the battery cover. Press and slide open the battery cover.
  • Press and slide open the battery cover.

Agregar Comentario

Caution: Turn cell phone off before removing battery!
  • Caution: Turn cell phone off before removing battery!

  • Press battery to the right.

  • Then lift up battery pack to remove.

Agregar Comentario

Phone with battery removed
  • Phone with battery removed

Agregar Comentario

Remove the touchpad pen from the top left corner on the back to reveal the last of 6 screws to be removed.
  • Remove the touchpad pen from the top left corner on the back to reveal the last of 6 screws to be removed.

Agregar Comentario

Lift the rubber cap at the top right to reveal the sixth screw.
    • Lift the rubber cap at the top right to reveal the sixth screw.

    • Caution: There is a small Palm sticker under the rubber cap. Tampering with or removing this sticker will void your warranty!

    • Remove the six screws using the T5 Torx screwdriver.

Agregar Comentario

Remove the SIM card so housing can be separated. Remove the SIM card so housing can be separated.
  • Remove the SIM card so housing can be separated.

Agregar Comentario

Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert. Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert.
  • Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert.

Agregar Comentario

Remove the small plastic insert at the bottom of the phone. Remove the small plastic insert at the bottom of the phone.
  • Remove the small plastic insert at the bottom of the phone.

Agregar Comentario

Continue with plastic pry tool all the way around the phone to remove the back housing. Continue with plastic pry tool all the way around the phone to remove the back housing.
  • Continue with plastic pry tool all the way around the phone to remove the back housing.

Agregar Comentario

Carefully peel back the tape holding the speaker (left) and keyboard (right) connection tabs in place.
  • Carefully peel back the tape holding the speaker (left) and keyboard (right) connection tabs in place.

Agregar Comentario

Using the plastic prying tool, lift the tabs and carefully pull the contact connections out on both sides.
  • Using the plastic prying tool, lift the tabs and carefully pull the contact connections out on both sides.

    • Be very careful, these electronics are delicate!

Agregar Comentario

Separate the logic board from the case by lifting and pulling out the bottom.
  • Separate the logic board from the case by lifting and pulling out the bottom.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Equipo

Cal Poly, Team 15-49, Garner Spring 2010 Miembro de Cal Poly, Team 15-49, Garner Spring 2010

CPSU-GARNER-S10S15G49

5 Miembros

12 Guías creadas

note: if you need to replace the logic board, follow this guide, insert a new board, and then follow the steps in reverse order to get a working phone.

Chelsea Barackman - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 2,914