Introducción

This guide will explain step by step how to remove the outer cases of the IBM WorkPad c3.

Partes

No se requieren partes.

Turn the device over so that the screen is facing down. In the next step the device will be heated, so the screen must be turned over to prevent heat damage to the LCD/Digitizer.
  • Turn the device over so that the screen is facing down.

  • In the next step the device will be heated, so the screen must be turned over to prevent heat damage to the LCD/Digitizer.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Using a hair dryer, slowly heat the edges of the WorkPad.
  • Using a hair dryer, slowly heat the edges of the WorkPad.

  • Spend at least one minute heating each side of the device. This will melt the glue holding the case together, and allow it to be removed.

  • Be sure not to touch the device directly after heating as it will be extremely hot. Use a towel or oven mitt to grab it.

Agregar Comentario

Use a plastic opening tool to pry the back case from the WorkPad. If the rear cover is not coming off very easily, you probably need to reheat the case in order to sufficiently melt the glue.
  • Use a plastic opening tool to pry the back case from the WorkPad.

  • If the rear cover is not coming off very easily, you probably need to reheat the case in order to sufficiently melt the glue.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Emily Falkenstein

Miembro Desde 05/10/10

51 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 21-35, Regan Fall 2010 Miembro de Cal Poly, Team 21-35, Regan Fall 2010

CPSU-REGAN-F10S21G35

3 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 4

Todo El Tiempo: 1,214