Saltar al contenido principal

Disassembling Canon PowerShot SD800 IS LCD Display

Qué necesitas

  1. Disassembling Canon PowerShot SD800 IS LCD Display, Back Cover: paso 1, imagen 1 de 1
    • Remove one 2.25mm screw on the bottom.

  2. Disassembling Canon PowerShot SD800 IS LCD Display: paso 2, imagen 1 de 1
    • Remove two 2.25mm screws on the right side looking from the front.

  3. Disassembling Canon PowerShot SD800 IS LCD Display: paso 3, imagen 1 de 1
    • Remove one 4.7mm screw on the side with the AV output.

  4. Disassembling Canon PowerShot SD800 IS LCD Display: paso 4, imagen 1 de 1
    • Pull off the back cover.

    • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

  5. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Assembly: paso 5, imagen 1 de 1
    • Remove 2 2.4mm screws on bottom.

  6. Disassembling Canon PowerShot SD800 IS LCD Display: paso 6, imagen 1 de 1
    • Follow the small data cable to where it connects to the camera.

    • Lift the back white portion to unlock the cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  7. Disassembling Canon PowerShot SD800 IS LCD Display: paso 7, imagen 1 de 1
    • Gently lift LCD display off.

    • There will be two data cables still attached to the camera. Do not break them.

    • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

  8. Disassembling Canon PowerShot SD800 IS LCD Display: paso 8, imagen 1 de 1
    • Follow the larger cable to where it connects to the camera.

    • Lift the front black portion of the connector to unlock the data cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  9. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Display: paso 9, imagen 1 de 1
    • Pry the LCD display out from the four metal clamps.

  10. Disassembling Canon PowerShot SD800 IS LCD Display: paso 10, imagen 1 de 1
    • To remove the LCD, peel the larger data cable off from the frame.

    • The LCD is glued by its data cable to the back of the LCD frame.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Miembro Desde 10/10/10

135 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 20-9, Maness Fall 2010 Miembro de Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 2,689