Introducción

Follow this guide to remove the LCD Display.

Partes

No se requieren partes.

Insert a spludger into the notch at the far left side of the top blue panel and pry hinge cover off. Note: You may need to pry the other side off by inserting the spludger between the hinge and the top cover. Be careful of wire attached to underside of the hinge cover.
  • Insert a spludger into the notch at the far left side of the top blue panel and pry hinge cover off.

  • Note: You may need to pry the other side off by inserting the spludger between the hinge and the top cover.

  • Be careful of wire attached to underside of the hinge cover.

Agregar Comentario

Pull the small black tab on the right hand side of the laptop.
  • Pull the small black tab on the right hand side of the laptop.

  • The hinge cover has now been removed.

Agregar Comentario

Flip the laptop over and remove the indicated screws. Flip the laptop back over.
  • Flip the laptop over and remove the indicated screws.

  • Flip the laptop back over.

  • Find the two places where the display module is attached to the base of the computer.

Agregar Comentario

Disconnect the video card from the display module by gently lifting upwards on the black tab.
  • Disconnect the video card from the display module by gently lifting upwards on the black tab.

Agregar Comentario

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Lift the display module directly upwards from the base of the computer. Lift the display module directly upwards from the base of the computer.
  • Lift the display module directly upwards from the base of the computer.

Agregar Comentario

The display module has been removed.
  • The display module has been removed.

Agregar Comentario

First, remove the plastic tabs that are covering the interior screws. After removing the tabs, remove the interior screws using a #1 Philips Screwdriver. Note there are 8 tabs and 8 screws in total.
  • First, remove the plastic tabs that are covering the interior screws.

  • After removing the tabs, remove the interior screws using a #1 Philips Screwdriver.

  • Note there are 8 tabs and 8 screws in total.

Agregar Comentario

Now that the screws are removed, press the plastic casing inward to loosen the case. Then remove the plastic case from the monitor unit.
  • Now that the screws are removed, press the plastic casing inward to loosen the case. Then remove the plastic case from the monitor unit.

Agregar Comentario

Using a Philips #1 screwdriver remove the screws holding the LCD in place.
  • Using a Philips #1 screwdriver remove the screws holding the LCD in place.

  • Note there are 8 screws in total for this step, 4 on each side of the unit.

Agregar Comentario

Remove the broken LCD unit, and replace with new unit.
  • Remove the broken LCD unit, and replace with new unit.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Perry

Miembro Desde 12/04/11

239 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 18-22, Garner Spring 2011 Miembro de Cal Poly, Team 18-22, Garner Spring 2011

CPSU-GARNER-S11S18G22

4 Miembros

15 Guías creadas

which controller board do i have to use for this model ?

bcdoor - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 8

Todo El Tiempo: 4,217