Saltar al contenido principal

Cleaning the Fan Blades

Qué necesitas

  1. Cleaning the Fan Blades, PCB (Printed Circuit Board): paso 1, imagen 1 de 1
    • Use the Phillips #2 screwdriver to remove the four 6 mm screws by unscrewing counterclockwise.

  2. Cleaning the Fan Blades: paso 2, imagen 1 de 1
    • Pull the front and back cover apart.

    • Be careful not to pull the front cover off completely. It holds the wires.

  3. Cleaning the Fan Blades: paso 3, imagen 1 de 1
    • Remove the Phillips 6 mm screw that holds the circuit board to the outer shell of the fan.

    • Shock warning: Make sure the fan is unplugged before removing the circuit board.

  4. Cleaning the Fan Blades: paso 4, imagen 1 de 1
    • Remove the top cover containing the circuit board and the wires by pulling it away from the outer shell of the fan.

  5. Cleaning the Fan Blades: paso 5, imagen 1 de 2 Cleaning the Fan Blades: paso 5, imagen 2 de 2
    • Remove the screws from the four corners of the circuit board.

    • Remove the circuit board from the top cover.

    • Do not touch the other side of the circuit board to avoid damaging the circuit elements.

  6. Cleaning the Fan Blades, Fan Blades: paso 6, imagen 1 de 1
    • Follow steps 1-4 to remove the front, back, and top covers of the fan to reach the fan blades.

    • Use a cloth to clean off dust clogged in between the fan blades.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Vivian Fong

Miembro Desde 09/26/12

97 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 15-46, Forte Fall 2012 Miembro de Cal Poly, Team 15-46, Forte Fall 2012

CPSU-FORTE-F12S15G46

5 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 6

Ultimos 30 días: 42

Todo El Tiempo: 10,003