Introducción

Replacing the heating tank should it fail to work.

Use a Phillips #0 screwdriver to remove the following ten screws: Four 18mm Phillips screws. Four 9.75mm Phillips screws.
  • Use a Phillips #0 screwdriver to remove the following ten screws:

    • Four 18mm Phillips screws.

    • Four 9.75mm Phillips screws.

    • Two 8mm Phillips screws.

    • The cover will not remove entirely. Keep green ground wire attached to the cover.

Agregar Comentario

Remove the two 14.5 Phillips screws. Ensure that only the water inlet valve can be moved.
  • Remove the two 14.5 Phillips screws.

  • Ensure that only the water inlet valve can be moved.

Agregar Comentario

Use a Phillips #0 screwdriver to remove the following six screws: Six 14.5mm Phillips screws.
  • Use a Phillips #0 screwdriver to remove the following six screws:

    • Six 14.5mm Phillips screws.

Agregar Comentario

Remove the power cord from the groove. (the black cord that leads into the green wire.) This creates more slack in the wire to give you more room to work with.
    • Remove the power cord from the groove. (the black cord that leads into the green wire.)

    • This creates more slack in the wire to give you more room to work with.

    • DO NOT remove green wire from the cover its attached to.

Agregar Comentario

Identify the hose that connects to the heating tank. (Observe that it is held up on a small hook.) Push down on the hook and carefully move the hose from its grip.
    • Identify the hose that connects to the heating tank. (Observe that it is held up on a small hook.)

    • Push down on the hook and carefully move the hose from its grip.

Agregar Comentario

Carefully pull out the heating tank by hand.
    • Carefully pull out the heating tank by hand.

    • The heating tank may still be hot. Exercise caution when grabbing hold of the tank. If necessary, wait four to six hours after last use.

    • Reminder for reassembly; You will need a new band to tie the hose back to the heating tank.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Antonio

Miembro Desde 26/09/12

73 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 1-3, Propen Fall 2012 Miembro de Cal Poly, Team 1-3, Propen Fall 2012

CPSU-PROPEN-F12S1G3

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 3

Últimos 30 Días: 25

Todo El Tiempo: 3,285