Asus X502C-RB01 Fan Replacement

Introducción

If your laptop fan gets clogged with too much dust or is spinning too loud, you might want to clean or replace it. This guide will show you how to get to the fan and remove it to do so.

Qué necesitas

Paso 1 Keyboard Panel

Asus X502C-RB01 Fan Replacement, Keyboard Panel: paso 1, imagen 1 de 1

Turn off the laptop and flip it face down.
Using a Phillips #0 screwdriver, remove the seven 9mm screws circled in red.
With the same screwdriver, remove the four 5mm screws circled in orange.

Editar

Paso 2

Flip the laptop face up and open the lid.
Use the plastic opening tool to pry around the entire edge of the keyboard panel to loosen the panel from the base.
Be careful not to lift the panel just yet, as it is still connected to the motherboard.

Editar

Paso 3

Partially lift the panel up, revealing the two cables connected to the motherboard.

Editar

Paso 4

Disconnect the first ZIF cable by lifting the tab using the spuger tool or your fingernail and gently pull the cable out.
Disconnect the second ZIF cable by lifting the tab using your fingernail and gently pull the cable out. This one is more difficult to reach with the spudger.

Editar

Paso 5

Remove the keyboard panel completely and set it aside. The internal components of the laptop are now exposed.

Editar

Paso 6 Hard Drive

Asus X502C-RB01 Fan Replacement, Hard Drive: paso 6, imagen 1 de 1

Locate the hard drive in the area highlighted in red.
This demonstration model does not have a mounting bracket around the hard drive.

Editar

Paso 7

Remove the four 5mm screws from the hard drive mounting bracket using the Phillips #0 screwdriver.

Editar

Paso 8

Slide the hard drive in the direction away from the connector and lift it up to remove it.

Editar

Paso 9 Motherboard

Asus X502C-RB01 Fan Replacement, Motherboard: paso 9, imagen 1 de 1

Unplug the battery from the laptop by lifting the connector up with the flat end of the spudger.
Unplug the two ZIF cables by lifting the tab using the spudger tool or your fingernail then pulling the cable out gently.

Editar

Paso 10

Unplug the bundled cable by pulling it away from the connector with a bit of force.
Unplug the display cable connector by lifting the tape and pulling it away from the connector.
Unplug the two antenna cables connected to the network interface card by prying it off with the flat end of the spudger.