Saltar al contenido principal

Apple TV 1st Generation AirPort Card Replacement

Qué necesitas

  1. Apple TV 1st Generation AirPort Card Replacement, Lower Case: paso 1, imagen 1 de 1
    • Flip the Apple TV over so that the bottom of the unit is facing up.

    • You need to remove the rubber base to get access to the screws.

    • Starting at one side of the device, use a hairdryer or a heat gun to soften the adhesive holding the rubber base in place.

    • The rubber base will be hot after heating, take extreme caution while proceeding to avoid personal injury.

    • While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate.

    • The rubber base can tear if the adhesive hasn't been softened enough.

    • Repeat the procedure described above until the rubber base has been completely removed.

  2. Apple TV 1st Generation AirPort Card Replacement: paso 2, imagen 1 de 1
    • Remove the four T10 Torx screws that secure the lower case to the upper case.

  3. Apple TV 1st Generation AirPort Card Replacement: paso 3, imagen 1 de 1
    • Carefully lift the lower case from the upper case enough to allow access to the internals of the Apple TV.

    • Be aware that the hard drive is physically attached to the lower case and that a ribbon cable runs from the drive to the logic board in the upper case.

  4. Apple TV 1st Generation AirPort Card Replacement: paso 4, imagen 1 de 2 Apple TV 1st Generation AirPort Card Replacement: paso 4, imagen 2 de 2
    • Carefully pull the hard drive data cable straight up from its socket on the logic board.

    • During reassembly, make sure the hard drive data cable is firmly seated in its socket on the logic board; otherwise, during boot-up you will see a flashing question mark "?".

  5. Apple TV 1st Generation AirPort Card Replacement, AirPort Card: paso 5, imagen 1 de 1
    • Pry the AirPort antenna cables straight up from their sockets on the logic board.

  6. Apple TV 1st Generation AirPort Card Replacement: paso 6, imagen 1 de 1
    • Remove the single T8 Torx screw securing the AirPort card to the logic board.

  7. Apple TV 1st Generation AirPort Card Replacement: paso 7, imagen 1 de 1
    • Cautiously lift the AirPort card and pull it straight away. Slide it from its socket on the logic board.

Conclusión

To reassemble your device, follow these instructions in reverse order.

11 personas más completaron esta guía.

ropel

Miembro Desde 11/11/09

113 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 18-5, Maness Fall 2009 Miembro de Cal Poly, Team 18-5, Maness Fall 2009

CPSU-MANESS-F09S18G5

5 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 6

Todo El Tiempo: 13,362