Introducción

This guide will help you remove and replace your computers speaker, if speaker is not working properly or at all.

Partes

No se requieren partes.

Remove the six 19 mm long screws with a #2 Phillips head screwdriver. Remove the six 19 mm long screws with a #2 Phillips head screwdriver.
  • Remove the six 19 mm long screws with a #2 Phillips head screwdriver.

Agregar Comentario

Release the catch by pushing it in using a plastic opening tool. The catch is off-center, but in line with the middle of the speaker underneath.
  • Release the catch by pushing it in using a plastic opening tool.

    • The catch is off-center, but in line with the middle of the speaker underneath.

Agregar Comentario

Slide the case toward the ports on the back, then grip under the catch and pull up while moving toward the ports to remove. Slide the case toward the ports on the back, then grip under the catch and pull up while moving toward the ports to remove.
  • Slide the case toward the ports on the back, then grip under the catch and pull up while moving toward the ports to remove.

This step is wrong. The ports cover should be removed with a plastic disassembly tool first. Failure to do this will lead to a set of broken plastic hooks.

cybernesto - Contestar

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Lift the handle straight up to remove. Lift the handle straight up to remove.
  • Lift the handle straight up to remove.

Agregar Comentario

Tilt the keyboard up while detaching the ribbon connection by pulling it straight up.  You may have to wiggle the connector sideways to loosen it. Be careful not to force the ribbon while pulling it out to avoid tearing.  Do not try to pull the ribbon out by pulling the keyboard as it may cause tearing.
  • Tilt the keyboard up while detaching the ribbon connection by pulling it straight up. You may have to wiggle the connector sideways to loosen it.

  • Be careful not to force the ribbon while pulling it out to avoid tearing. Do not try to pull the ribbon out by pulling the keyboard as it may cause tearing.

Agregar Comentario

Unplug the speaker from the mother board by pulling horizontally.
  • Unplug the speaker from the mother board by pulling horizontally.

Agregar Comentario

Heat the glue to loosen it, then wiggle the speaker up and out. Use the screwdriver to scrape off the remaining glue.
  • Heat the glue to loosen it, then wiggle the speaker up and out. Use the screwdriver to scrape off the remaining glue.

  • An easy way to heat the glue is by using a hair dryer on a low setting.

  • When heating the glue, do not use any high wattage device! This may burn or damage the chips or circuit board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Josiah

Miembro Desde 06/10/11

515 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 21-23, Maness Fall 2011 Miembro de Cal Poly, Team 21-23, Maness Fall 2011

CPSU-MANESS-F11S21G23

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 971