Introducción

How to open the converter box and replace the power supply...

Unplug your device from the wall outlet.
  • Unplug your device from the wall outlet.

Agregar Comentario

Remove the screws on the sides and rear. There are two on each side and four on the back.
  • Remove the screws on the sides and rear. There are two on each side and four on the back.

  • Note: only remove the black ones (the silver ones stay for now). You should have removed eight identical screws by now.

Agregar Comentario

Lift the top cover up and toward you simultaneously. It shouldn't require very much force.
  • Lift the top cover up and toward you simultaneously. It shouldn't require very much force.

Agregar Comentario

Locate the power board inside the converter box.
  • Locate the power board inside the converter box.

  • Circled in red in the picture.

Agregar Comentario

Remove this plug
  • Remove this plug

  • You will need to squeeze the locking lever to release it. don't pull too hard.

  • Circled in red in the picture.

Agregar Comentario

Remove this plug from the main board. It is not detachable from the power board end.
  • Remove this plug from the main board. It is not detachable from the power board end.

  • Be gentle.

  • Circled in red in the picture

Agregar Comentario

Remove one last cable. This one leads to the front panel
  • Remove one last cable. This one leads to the front panel

  • Be gentle.

  • Circled in red

Agregar Comentario

Remove the power cord from its slot in the casing. This will make it easier to remove the power board.
  • Remove the power cord from its slot in the casing. This will make it easier to remove the power board.

  • Circled in blue

Agregar Comentario

Remove the four silver colored philips screws holding the power board in.
  • Remove the four silver colored philips screws holding the power board in.

  • Marked in pink (eeww)

Agregar Comentario

Lift the power board out. Be careful to not touch the bottom of the power board. even when unplugged, it may still hold a charge.
  • Lift the power board out. Be careful to not touch the bottom of the power board. even when unplugged, it may still hold a charge.

  • Here is the empty spot.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Michel

Miembro Desde 18/06/10

261 Reputación

1 Guía escrita

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 18

Todo El Tiempo: 8,513