Saltar al contenido principal
Inglés
Español
Paso 3
Remove the two Phillips screws. The casing will simply unsnap. The complete circuit board will be immediately visible. Here is the connector end. Note the wax on the small wires. This is probably to prevent the very small wires from moving too much on the board.
  • Remove the two Phillips screws. The casing will simply unsnap.

  • The complete circuit board will be immediately visible.

  • Here is the connector end. Note the wax on the small wires. This is probably to prevent the very small wires from moving too much on the board.

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.