Menú

Tus configuraciones

Mi Mesa de Trabajo

Obtén acceso rápido a guías, partes y respuestas para tus dispositivos
Mi Carrito

Al parecer tu carrito está vacío

Visita Nuestra Tienda
Volver a la Guía
Inglés
Español
Paso 34
Give the plastic beads a few seconds to cool, then remove them and mash them together until they form one piece. The plastic beads should be fairly warm still, but their container will likely be extremely hot. Use care when removing and handling the beads.

  • Give the plastic beads a few seconds to cool, then remove them and mash them together until they form one piece.

  • The plastic beads should be fairly warm still, but their container will likely be extremely hot. Use care when removing and handling the beads.

  • Stretch the glob of plastic into a thin strip that will fill one of the gaps between the case halves.

  • Press the plastic into the crevices and smooth it out with your finger.

  • If the plastic becomes too hard to work with, you can re-apply heat to loosen the plastic.

  • Be cautious if you reheat the plastic while it's in the case. Allow cooling periods between reheating so you don't accidentally de-solder any components.

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.