Saltar al contenido principal

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 5 guías que incluyen este paso.

Inglés
Francés

Traduciendo paso 3

Paso 3
Use a 000 phillips head screwdriver to remove the 10 1.2mm phillips head screws in the plastic frame that hold the motherboard and battery. Use a 000 phillips head screwdriver to remove the 3 0.5mm phillips head screws in the plastic frame that hold the motherboard and battery. Use the small plastic opening tool and place it in the slot on the bottom right corner of the inner frame and carefully pry it off.
  • Use a 000 phillips head screwdriver to remove the 10 1.2mm phillips head screws in the plastic frame that hold the motherboard and battery.

  • Use a 000 phillips head screwdriver to remove the 3 0.5mm phillips head screws in the plastic frame that hold the motherboard and battery.

  • Use the small plastic opening tool and place it in the slot on the bottom right corner of the inner frame and carefully pry it off.

Placez les vis sur le tapis magnétique pour éviter de les perdre.

Utilisez un tournevis Phillips 3.0 pour enlever les 10 vis Phillips de 1,2 mm dans le cadre en plastique qui tenait la carte mère et la batterie.

Utilisez un tournevis Phillips 3.0 pour enlever les 3 vis Phillips de 0,5 mm dans le cadre en plastique qui a retenu la carte mère et la batterie.

Utilisez le petit outil d'ouverture en plastiqueet placez-le dans la fente située dans le coin inférieur droit du cadre intérieur et retirez-le soigneusement.

-[* icon_caution] Place the screws on the magnetic mat to avoid losing them.
-[* red] Use a 3.0 Phillip’s head screwdriver to remove the 10 1.2mm Phillip’s head screws in the plastic frame that held the motherboard and battery.
-[* orange] Use a 3.0 Phillip’s head screwdriver to remove the 3 0.5mm Phillip’s head screws in the plastic frame that held the motherboard and battery.
+[* red] Use a 000 phillips head screwdriver to remove the 10 1.2mm phillips head screws in the plastic frame that hold the motherboard and battery.
+[* orange] Use a 000 phillips head screwdriver to remove the 3 0.5mm phillips head screws in the plastic frame that hold the motherboard and battery.
[* yellow] Use the small [product|IF145-000|plastic opening tool] and place it in the slot on the bottom right corner of the inner frame and carefully pry it off.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.