Saltar al contenido principal
Francés
Inglés

Kenwood Chef: Replacing the SER1018 Planetary set

Información de Guía

= Hecho = Incompleto

      Describe la parte específica o el componente específico de este device en que estás trabajando. Ex: Batería

      Crear un título.

      Este breve resumen de 1-2 oraciones aparecera en los resultados de búsqueda.

      Comunica información antes de que el lector empieze a leer la guía.

      Pasos de Guía

      Paso 1 — Remove the locking latch knob

      Remove the button

      Paso 2 — Remove the sun gear

      Unscrew the hex nut

      Paso 3 — Bottom of the machine

      Remove the bottom of the machine

      Paso 4 — Fast and medium speed outputs

      Unscrew the screws on each side of the circular discs to remove the circular plastic discs

      Paso 5 — Housing cover

      Unscrew the three Torx screws

      Paso 6 — The challenge: loosen the hidden screw

      It is not necessary to proceed to the next step if the plastic drive wheel has been removed

      Paso 7 — Special Tool

      I modified an open end wrench to drive a Tx20 bit

      Paso 8 — Open the housing

      Remove the guides (red mark). They can be reassembled after closing the housing

      Paso 9 — Planetary

      The former one has a cross fromation.

      Paso 10 — Training axis

      The former one has a cross patteren

      Paso 11 — Labels

      Cod. SER1018: Plastic bag containing the three spare parts

      Paso 12 — Fitting the gears

      Place each gear on the axis

      Paso 13 — Crank Case Assembly

      There is a lot of greasein the case. Spread the grease on the surfaces that need it.

      Paso 14 — Hidden screw

      Screw the hidden screw back in

      Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.