Saltar al contenido principal
Inglés
Italiano
Paso 7
Remove the piece of tape covering the remaining two leads. If you are satisfied with the position of the cable relative to the pads on the board, proceed. If not, de-solder the first connection and try again. Solder the two remaining pads to the logic board, being mindful of overheating the cable or board.
  • Remove the piece of tape covering the remaining two leads. If you are satisfied with the position of the cable relative to the pads on the board, proceed. If not, de-solder the first connection and try again.

  • Solder the two remaining pads to the logic board, being mindful of overheating the cable or board.

Rimuovi il pezzo di nastro che copre i restanti due contatti. Se sei soddisfatto della posizione del cavo rispetto ai contatti sulla scheda, continua. Altrimenti dissalda la prima saldatura e riprova.

Salda i due contatti rimasti sulla scheda madre, stando attento a non surriscaldare il cavo o la scheda.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.