Saltar al contenido principal

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 4 guías que incluyen este paso.

Inglés
Francés
Paso 2
Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner. Remove the 27mm screw using the T6 Torx screwdriver.
  • Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.

  • Remove the 27mm screw using the T6 Torx screwdriver.

  • If there is a red Palm sticker covering this screw, puncture it to access the screw.

En utilisant le spudger, retirez le couvercle rectangulaire en caoutchouc situé dans le coin supérieur droit de l'appareil.

Dévissez la vis de 0,266 pouces avec le tournevis Torx T6.

Si un autocollant de couleur rouge recouvre la vis, il suffit de la percer pour accéder à la vis.

-[* yellow] Using the spudger, remove the rubber rectangular cover located in the upper right hand side of the device.
-[* red] Unscrew the 0.266 inch screw with the T6 Torx Screwdriver.
- [* icon_note] If there is a red Palm sticker covering the screw, just puncture it to access the screw.
+[* red] Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.
+[* orange] Remove the 27mm screw using the T6 Torx screwdriver.
+ [* icon_note] If there is a red Palm sticker covering this screw, puncture it to access the screw.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.