Saltar al contenido principal

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 5 guías que incluyen este paso.

Inglés
Chino

Traduciendo paso 7

Paso 7
To avoid straining the display cables, don't open the display all the way yet. Open the display at max. to an 45° angle, and use tweezers to peel off the adhesive between the display and the Force Touch gasket. Thread the adhesive around and behind the display cables to get it off completely.  Since the adhesive needs to be replaced anyway, you can cut it if that makes removal easier for you.
  • To avoid straining the display cables, don't open the display all the way yet.

  • Open the display at max. to an 45° angle, and use tweezers to peel off the adhesive between the display and the Force Touch gasket.

  • Thread the adhesive around and behind the display cables to get it off completely. Since the adhesive needs to be replaced anyway, you can cut it if that makes removal easier for you.

  • Make sure to return to this point during the reassembly of your watch and then continue with the Resealing Procedure.

为避免拉紧显示屏电缆,请不要完全打开显示屏。

最大打开显示屏到45度角,并用镊子将显示屏和Force Touch垫圈之间的粘合剂剥落。

将缠绕在显示电缆的周围和后面的粘合剂完全清除。由于粘合剂仍然需要更换,因此如果可以方便地去除胶粘剂,则可以对其进行切割。

请确保在重新组装手表时返回到这一点,然后继续执行“重新密封”程序。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.