Saltar al contenido principal

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 5 guías que incluyen este paso.

Inglés
Chino
Paso 6
It's likely that the Force Touch sensor will stick to the display frame instead to the watch's body. In this case, insert an opening pick under the display and carefully separate the Force Touch gasket from the display. To preserve the Force Touch gasket, pry carefully under the edge of the display. If the Force Touch gasket splits when lifting the display, or if you separate the gasket layers, you'll also need to replace the Force Touch gasket itself. Slide the pick around the display to separate the adhesive between the Force Touch gasket and the display.
  • It's likely that the Force Touch sensor will stick to the display frame instead to the watch's body. In this case, insert an opening pick under the display and carefully separate the Force Touch gasket from the display.

  • To preserve the Force Touch gasket, pry carefully under the edge of the display. If the Force Touch gasket splits when lifting the display, or if you separate the gasket layers, you'll also need to replace the Force Touch gasket itself.

  • Slide the pick around the display to separate the adhesive between the Force Touch gasket and the display.

  • Don't insert the opening pick deeper than 1/16th of an inch (~2 mm) to avoid damaging other components.

Force Touch 传感器可能会粘在显示屏框架上,而不是粘在手表的身上。在这种情况下,在显示器下方插入一个三角撬片,然后小心地将Force Touch垫圈从显示器上拆下。

要保留Force Touch垫圈,请在显示屏边缘下方小心撬动。如果抬起显示屏时Force Touch垫圈裂开,或者分开了垫圈层,则还需要更换Force Touch垫圈本身。

在显示屏上滑动拨片,以分离力触式垫片和显示屏之间的粘合剂。

不要将三角撬片插入的深度不超过1/16英寸(〜2 mm),以免损坏其他组件。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.