Repara tus cosas Derecho a reparar Tienda

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 10 guías que incluyen este paso.

Volver a la Guía
Inglés
Español
Siguiente paso

Traduciendo paso 1

Paso 1
Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
Heat the back cover

  • Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.

  • Turn your phone off completely before you begin this repair.

  • Prepare an iOpener and heat the back of the phone along the right edge for about two minutes. This will help soften the adhesive securing the back cover.

  • You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.

Calienta la tapa trasera

Abrir el dispositivo pondrá en riesgo tu sellado impermeable. Ten preparado adhesivo de repuesto antes de proceder o trata de evitar exposición a líquidos si vuelves a montar el dispositivo sin sustituir el adhesivo.

Prepara un iOpener y calienta la parte trasera del teléfono a lo largo del borde derecho durante aproximadamente dos minutos. Esto ayudará a ablandar el adhesivo que sujeta la tapa trasera.

Necesitarás volver a calentar y aplicar el iOpener varias veces para alcanzar la temperatura suficiente. Consulta las instrucciones del iOpener para evitar sobrecalentamiento del dispositivo.

También se puede usar un secador de pelo, una pistola caliente o una placa caliente, pero ten cuidado de no sobrecalentar el teléfono. La pantalla OLED y la batería interna son susceptibles de sufrir daños por calor.

[title] Heat the back cover
[* icon_note] Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
[* black] Turn your phone off completely before you begin this repair.
[* black] [guide|25705|Prepare an iOpener|new_window=true] and heat the back of the phone along the right edge for about two minutes. This will help soften the adhesive securing the back cover.
[* icon_note] You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.
[* icon_caution] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.