Inglés
Español
Paso 30
This is one way to wire the electronics. You can adjust this to your needs/preference. The Pinda wire runs over the left top of the X-Carriage The motor wire runs over the top of the extruder. Make sure to leave some slack so you can open the idler freely
Wiring - Option 1
  • This is one way to wire the electronics. You can adjust this to your needs/preference.

  • The Pinda wire runs over the left top of the X-Carriage

  • The motor wire runs over the top of the extruder. Make sure to leave some slack so you can open the idler freely

  • The fan wires run over the right top of the X-Carriage. You can secure them with a zip tie

  • The filament sensor wire just runs straight down the back

  • Use some braided sleeve or something similar around the wires. Use zip ties to secure the bundle to the X-Clamp and Tail. Make sure to align the zip tie heads on the left, so they do not become an obstacle during homing.

  • If the heater cartridge wires are too close to the bed, running underneath the X-Clamp, route them around the side as shown in picture 3

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.