Inglés
Español
Paso 21
Insert the Pinda into P-Rack as shown in picture 1, getting it close to level with the nozzle. Don't worry too much about the exact Pinda position. With the knob on you can easily adjust its height later when calibrating the printer
Pinda
  • Insert the Pinda into P-Rack as shown in picture 1, getting it close to level with the nozzle.

  • Don't worry too much about the exact Pinda position. With the knob on you can easily adjust its height later when calibrating the printer

  • Use M3x8 to tighten the Pinda. Make sure it does not slip

  • Depending on the force needed, hold the P-Rack to support it when tightening the Pinda to avoid bending it

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.