Saltar al contenido principal
Inglés
Español

Traduciendo paso 1

Paso 1
Remove the three 10 mm Phillips #1 screws connecting the balance sensor to the hoverboard. The balance sensor tabs are made of sensitive rubber. Screw them back on slowly, and do not over-tighten. The balance sensor tabs are made of sensitive rubber. Screw them back on slowly, and do not over-tighten.
  • Remove the three 10 mm Phillips #1 screws connecting the balance sensor to the hoverboard.

  • The balance sensor tabs are made of sensitive rubber. Screw them back on slowly, and do not over-tighten.

Insertar traducción aquí

Insertar traducción aquí

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.