Saltar al contenido principal

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 6 guías que incluyen este paso.

Inglés
Japonés
Paso 2
Flip over the device again, so that the bottom is facing upwards. Using a Torx T10 screwdriver, remove the two screws located on opposite sides of the metal casing. One is near the fan vent, and the other is near the power supply vent.
  • Flip over the device again, so that the bottom is facing upwards.

  • Using a Torx T10 screwdriver, remove the two screws located on opposite sides of the metal casing. One is near the fan vent, and the other is near the power supply vent.

  • The left screw is 11mm and the right screw is 7.5 mm.

再度デバイスを裏返して、底部を上に向けます。

トルクス T10ドライバーをしようして、金属ケースの反対側にある2本のネジを取り外します。1本はファンの通風孔付近、もう1本は電源通風孔の付近にあります。

左のネジは11 ㎜、右のネジは7.5 ㎜です。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.