Saltar al contenido principal

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 6 guías que incluyen este paso.

Inglés
Francés
Paso 2
Flip over the device again, so that the bottom is facing upwards. Using a Torx T10 screwdriver, remove the two screws located on opposite sides of the metal casing. One is near the fan vent, and the other is near the power supply vent.
  • Flip over the device again, so that the bottom is facing upwards.

  • Using a Torx T10 screwdriver, remove the two screws located on opposite sides of the metal casing. One is near the fan vent, and the other is near the power supply vent.

  • The left screw is 11mm and the right screw is 7.5 mm.

Retournez à nouveau le périphérique, de sorte que le bas soit dirigé vers le haut.

À l'aide d'un tournevis Torx T9, retirez les deux vis situées de part et d'autre du boîtier en métal. L'un se trouve près de l'évent du ventilateur et l'autre, près de l'évent du bloc d'alimentation.

La vis de gauche mesure 11 mm et la vis de droite mesure 7,5 mm.

[* black] Flip over the device again, so that the bottom is facing upwards.
-[* red] Using a Torx T9 screwdriver, remove the two screws located on opposite sides of the metal casing. One is near the fan vent, and the other is near the power supply vent.
+[* red] Using a Torx T10 screwdriver, remove the two screws located on opposite sides of the metal casing. One is near the fan vent, and the other is near the power supply vent.
[* icon_note] The left screw is 11mm and the right screw is 7.5 mm.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.